How to Install Bamboo Floor Firstly clean the area where bamboo floor will be installed; Flatly plane the normal long strip(keel),then nail it with 3-4cm long nails on cement ground,the keel's gap is around 25 cm; 5 keels are horizontally crossed under bamboo floor, anti-moth medicament(Chinese prickly ash particle)is distributed under the floor,half of a catty of Chinese prickly ash particle should be distributed per square meter; Drill holes at the side part of the bamboo floor,it's better to nail a 1.5 inch spiral nail;put a little glue at the joint of keel and floor,then start to install the floor; 1-1.5 cm of air-hole should be left around the floor firstly,then arrange the ground line; It should be specially mentioned that the installtion quality would directly effect the whole usage result of the bamboo floor,so please let experienced carpenter to install the floor. General Knowledge of Maintaining Bamboo Floor Not seal the lower layer of floor with cement; Not install the board too tightly; Not let floor be wet by water spilled from balcony,both-room or kitchen; Not sprinkle water on floor for clean,only wet cloth wrung dry can be used; Why Can Bamboo Floor Be Anti-Moth,Never Deformed and Wear Resistant? Anti-moth medicament is added in the bamboo material during the process of bleaching and the floor is de-sugar through hi-temperature and pressure during the process of carbonizing; De-watering process will be finished after baking,so bamboo floor will be not deformed and be with elasticity; The fiber density of bamboo is higher than that of wood ,moreover,it is coated with UV paint,so that's why the bamboo floor wear-resistant;